Sea Recovery Aqua Whisper DX 1400-2, Руководство пользователя

Страница: 88 / 226

Aqua Whisper DX Modular 450-1800
Page 5-6
Installa
tion
Control Logic that the Fresh Water Tank is full.
When installed and connected to the Main Printed Circuit
Board, the Fresh Water Tank High Level Switch must be
connected as a N.C. (Normally Closed) 1PST (One Pole
Single Throw) switch.
When the Fresh Water Tank is several inches below
the full mark the switch is Closed. As water rises and
reaches the top of the full mark the switch Opens. This
informs the System Control Logic that the Fresh Water
Tank is full, the System will shut down if operating in
the Automatic mode, and the System will not start in the
Automatic mode.
If operation of the System is desired when the Fresh
Water Tank Switch signals the System Control Logic that
the Fresh Water Tank is full then the System may be
operated in the Manual mode.
Alarm ** owner/installer supplied provides an
optional feature to the System Control Logic that
audibly or visually signals the operator that the System
has stopped operating.
The output of this alarm circuit form the Main Printed
Circuit Board is 12 VDC with MAXIMUM allowable current
consumption of 1 (one) Ampere.
This alarm will signal if a fault occurs. It will not
signal with a normal shut down that was not
associated with a fault. to the Automatic mode of the System. The choice of
make, model, and style are left up to the Installer or
Owner. They must meet the electrical requirement and
operation as explained below.
The customer may also connect an external alarm to
the System which will alert the operator that they system
has shut down.
Fresh Water Tank Low Level Switch ** owner/installer
supplied provides an optional feature to the System
Control Logic that works in conjunction with the
Automatic Fresh Water Flush option.
When installed and connected to the Main Printed Circuit
Board, the Fresh Water Tank Low Level Switch must be
connected as a N.O. (Normally Open) 1PST (One Pole
Single Throw) switch.
When the Fresh Water Tank is empty the switch is Open.
As water rises a few inches in the tank the switch Closes.
This informs the System Control Logic that there is
sufficient Fresh Water to perform the Automatic Fresh
Water Flush Cycle.
Fresh Water Tank High Level Switch ** owner/installer
supplied provides an optional feature to the System
Control Logic that allows the System to shut off
automatically when the Fresh Water Tank is full, when the
System is operated in the Automatic mode. Additionally,
the System will not start in the Automatic mode when the
Fresh Water Tank High Level Switch signals the System
Outlet of To Inlet of
Inlet Connection Sea Strainer
Sea Strainer Rinse Clean Inlet Valve left or right port
Rinse Clean Inlet Valve unused left or right port Rinse/Clean container
Rinse Clean Inlet Valve center port Booster Pump
Booster Pump Prefilteration Options
Prefilter Option LP Manifold
Brine Discharge Tee Rinse Clean Discharge Valve
Rinse Clean Discharge Valve Cleaning Bucket
Rinse Clean Discharge Valve Brine Discharge Connector
Multi Media Filter Waste Line (if used)
Multi Media Filter Discharge Fitting separate
Thru-Hull or Tee at Brine Discharge Connector
pH Neutralizing Filter Ultra Violet Sterilizer
Ultra Violet Sterilizer Potable Water Storage Tank or Cistern
Component Interconnect Chart