Sea Recovery Aqua Whisper DX 1400-2, Руководство пользователя

Страница: 125 / 226

Aqua Whisper DX Modular 450-1800
Page 8-1
Maintenance
WARNING - ELECTRICAL SHOCK
HAZARD: A Volt / Ohm Meter will be
necessary. The following installation
procedures expose the installer to High
Voltage and electrical shock hazard.
Only attempt this if you are a qualified
electrician and only if surrounding
conditions are safe.
REVERSE OSMOSIS MEMBRANE ELEMENT
SUSCEPTIBILITY TO CHEMICAL ATTACK:
CAUTION : Do not expose the Sea
Recovery System to these chemicals:
Hydrogen peroxide chloramines-T
Chlorine dioxide chlorine
Bromine phenolic disinfectants
chloramines N-chlorioisocyanurates
hypochlorite iodine
Bromide petroleum products
or any other specific chemical not approved in
writing by Sea Recovery Corp. Use of non
authorized or misuse of authorized chemicals
voids warranty. Never use third party so called
“Reverse Osmosis Chemicals” for storage or
cleaning. Third Party chemicals will dissolve
copolymer components within the Sea Recovery
System and will destroy the R.O. membrane
element. Use of and subsequent damage caused
by non Sea Recovery Chemicals are the liability
and responsibility of the operator and are not
covered by the Sea Recovery Warranty.
Do not connect any water line to the Sea Recovery
R.O. System that may contain any of the above
listed chemicals. Examples: Do not connect the
Sea Recovery R.O. System to the ships potable
product water tank if that tank has been treated
with a Brominator as Bromine destroys the
copolymer components within the system. Do not
connect the Sea Recovery R.O. System to any line
that may contain chlorine or other oxidants as they
destroy the R.O. membrane element.
If you use detergents to clean the internal wetted
parts of the system ensure that they are rinsed
thoroughly, wiped and dried prior to reassembly.
After the components have been reassembled,
8 MAINTENANCE AND REPAIR
From time to time, Sea Recovery may make
programming changes to the Control Logic.
Other production changes are tracked by Sea Recovery
through the System Serial Number.
Troubleshooting methods and results can vary depending
on the information that is displayed at the SYSTEM
INFORMATION screen.
When ever requesting assistance from Sea Recovery or
one of Sea Recovery’s service dealers,
ALWAYS PROVIDE ALL INFORMATION
DISPLAYED AT THE SYSTEM INFORMATION
SCREEN.
• SERIAL NUMBER helps us to determine the latest
physical version and configuration of your system
which is necessary to ensure that we provide you
with the correct information or parts.
• TYPE tells us the production capacity of your system
which gives us a bench mark in diagnosing product
water flow and pressure concerns.
• TIME RUNNING assists us in diagnosing abnormalities
that can occur at given operational time intervals such
as required pump maintenance, or R.O. membrane
element condition.
• VERSION allows us to determine the specific
sequential operation of the system based on the
version of the programmed control logic.
AND Always provide us with the System Operating
Voltage, Cycles, and Phase.
QUALIFICATIONS
Technicians must have technical knowledge and ability in
the following fields:
a)
Electrical, Electronic, Electric Motors and Circuits
b) Electromechanical and Mechanical Systems
c) Hydraulic and Liquid Pressure and Flow Systems
d) Piping and Plumbing Systems
e) Water Suction and Pressure Lines
f) Thru-Hull Fitting below and above water level
DO NOT PERFORM MAINTENANCE UNLESS:
1. The System Feed Water Sea Cock Valve is closed.
2. The system main electrical disconnect switch is
switched “OFF”, LOCKED, and TAGGED.
3. Section 10, Exploded Parts View is available.