Sea Recovery Aqua Whisper DX 1400-2, Руководство пользователя

Страница: 93 / 226

Aqua Whisper DX Modular 450-1800
Page 5-11
Installa
tion
CAUTION ! Rapid successive cycling
of the power to the ballast can cause
premature failure of the unit.
CAUTION ! Prior to energizing the lamp,
make sure there is no water leaking from
the quartz sleeve compression nuts.
Mounting the Unit
Once the UV unit is assembled and tested successfully,
it can be mounted onto its permanent operational
location. The unit must be mounted in a manner that
will prevent excessive vibration and warping which will
damage the quartz sleeve.
Operational Guidelines
a) Release the pressure in the UV treatment chamber
before breaking the compression nut seals.
b) Disconnect all power to the UV unit
before servicing.
c) Do not allow the inlet water temperature to drop
below 35ºF (2ºC).
d)
Do not allow the flow rate to exceed 2 GPM (7.5 LPM).
e) Do not cycle the UV unit more than 3 “ON/OFF”
cycles in a 24-hour period.
f) Ensure all plumbing connections are tightly sealed
before applying pressure.
g) Before connecting the return tube, flush
the unit to rinse out any debris left from the
installation process.
WARNING ! UV LIGHT EXPOSURE
CAN SEVERELY BURN AND DAMAGE
EYES AND SKIN.
WARNING ! DO NOT look at the blue
UV light. DO NOT operate the UV lamp
outside of the UV treatment chamber.
CAUTION ! The unit operates on high
voltage and must be serviced by qualified
personnel only.
CAUTION ! Standard flow rate are based
on water temperature 35ºF to 100ºF
(2ºC to 38ºC). If the inlet water
temperature exceeds 100ºF (38ºC),
please contact your local CSR.
CAUTION ! Cycling more than 3 cycles
will reduce the end-of-life (EOL) output
and/or cause premature lamp failure.