Operation & Maintenance Manual
──
LG946L Wheel Loader
74
carried out carefully in gear .
Ⅰ
z
Lightly set the bucket edge facing down.
z
When driving the machine forward, operate the working equipment control lever to let the
lift arm lower down to the proper position so that it can
pick up a thin layer of the surface each time when
excavating the soil.
z
When driving the machine forward, shift the working
equipment control lever backward and forward slightly
to reduce the resistance.
△
!
NOTICE
Keep the two sides of the bucket cutting into the material equally
to prevent only a single side working. Face the loader forward and
never
let an angle exist between the front and rear frame.
(3)
Conveying Operation
The loader must be used without a truck under the following conditions:
z
The ground is too soft and not level, and the truck can not be used.
z
When the transportation distance is within 500 meters, it is not economical to use a truck.
z
The transportation driving speed is determined by the road condition.
z
In order to get good visibility and stability, the bucket should be turned to its upper limit
location(bucket lift-arm touch the upper limited block) and keep the lower pin connection
point of lift-arm at the transportation position (400~500mm above the ground).
(4)
Dumping Operation
z
When dumping material on to trucks or into freight
yards, raise the lift-arm to the position (forward tilt
to the maximum position) where the bucket does
not touch the carriage or material pole. And operate
working equipment control lever to tilt the bucket
forward to dump. Part or all of the material can be
dumped by the lever control. Act slowly and gently
during dumping to prevent the bucket from striking
