Operation & Maintenance Manual
──
LG946L Wheel Loader
22
usually soft.
Never
allow a turn over caused by the weight or vibration of the loader.
z
Never
drive the machine near hanging things or close to a deep ravine. The machine weight
or vibration may cause the ground to collapse, and result in the machine turning over.
z
Assemble anti-fall and anti-turn operator cab when working in an area where there is danger
of falling stone and machine turnover.
z
Continual rainy weather, earthquake and explosions can cause dangerous working conditions.
Operate carefully in these cases.
z
Drive at a low speed, prevent starting, braking or turning suddenly, and use the tire chain on
a snowy road. Brake alternately. Lower the bucket to touch the ground to brake if necessary.
z
The load should be decreased to prevent slippage when driving on snowy ground because
the adhesive force may change greatly in the piled snow.
z
The road shoulder and other road conditions can not be seen under the snow, so take care
with the snow shovel.
5.8 Driving safely on the Ramp
z
Turnover or slippage may occur when driving on an abrupt hill, dyke or ramp.
z
The bucket should be 200~300mm above the ground
when driving on an abrupt hill, dyke or ramp. Lower
the bucket and touch the ground to help brake or
prevent turn over in emergency conditions.
z
Do not turn on the ramp. Do not drive across the
ramp or change direction which may turn over the
machine until on the level place.
z
Never
turn on the ramp until on the level ground. Slow down and use a small turning angle
when working on an abrupt hill, dyke or ramp.
z
Go up and down the ramp rather than drive through alleyway or footpath.
z
Choose proper gears before going down the slope and never change the speed during going
down the slopes.
z
Do not suddenly brake on the ramp because the center of gravity is on the front tire or rear
tire.
z
Use gear I when driving on the ramp with a full load. Go forward when driving up the ramp,
go backward when driving down the ramp. Never turn around.
z
Brake slowly when driving down the ramp; do not set the gearshift control lever in the
