Operation & Maintenance Manual
──
LG946L Wheel Loader
64
check the clamper of safety belt whether lock and loose normally.
1.2.12 Rearview Mirror
Rearview mirrors are on the left and right sides outside the cab. Before starting work, the
rearview mirror must angle be adjusted for a good rear.
1.2.13 Fire annihilator
The prepared mounting hole of bracket about fire annihilator located on the frame on the right of
the operator seat, please fix the fire annihilator of meet national law and the place request.(Each
dealer of our company has reserved the fire annihilator and its bracket to choose.)
1.2.14 Key
This loader equips two key for every using condition:
z
The starting switch key for engine.
z
The key of left and right doors of cab.
z
The key of left and right doors of engine hood.
z
The key of left and right otter boards of engine hood.
z
The key for adding fuel port of fuel box (if mounted).
2 RUN-IN PERIOD OF NEW MACHINE
A new machine must have a run-in period first to increase the load step by step from free rotating;
so that each part of the machine can be have full run-in period for increasing the life of the
machine. It needs 60 hours to train the new machine, and operate follows:
z
Run the machine in neutral at low-speed to preheat the engine.
z
Never accelerate the engine suddenly in the preheating period.
z
Never start, accelerate, turn or brake suddenly except in an emergency.
z
When the loader is working without a load, the gearshift should be used from low speed to
high speed at each level accordingly. Turn left, right or brake steadily in the process of
driving.
z
In the period of run-in, all speeds including forward and reverse should be adjusted.
z
It is better to load bulk materials in the period of run-in. Do not operate the loader too hard
or too rudely. The load should be less than 70% of the standard load, and the speed should
be better less than 70% of the maximum speed limit.
z
Pay attention to the lubricating condition; routinely add and change the lubricant according
to rules.
z
Pay attention to the temperatures of the gearbox, torque converter, front and rear frame, rim
