Operation & Maintenance Manual
──
LG946L Wheel Loader
73
If the bucket hits the ground, the front tires will leave the ground and the tires will slip.
z
The operator must slow the speed immediately when
the machine reaches the material pile. Simultaneously
step on the accelerator pedal, and enter the material pile
with the bucket.
z
Keep the bucket horizontal when loading the stockpile,
but keep the dumping angle down when loading the
blasted rock.
Notice
:
Do not let the blasted rock go under the bucket which will
make the front tires leave from the ground and slip. Try to
hold the load in the center of the bucket; otherwise, if the
load is on one side of the bucket, it will be unbalanced.
z
Raise the lift arm to prevent the bucket from inserting
too deeply while thrusting the bucket into the material.
The tires will bring ample traction by raising the lift
arm.
z
If enough material is loaded into the bucket, operate
the working equipment control lever to take back the
bucket in order to load it fully.
Remark:
If the shovel edge moves up and down when thrusting material into the bucket or when digging,
the front tires will leave the ground and slip.
z
If there is too much material loaded into the bucket, the bucket must be dumped and titled
quickly to remove the excessive load so as to prevent the material from dispersing during
transportation.
Digging and Shoveling Material on Flat Ground
Lightly set the bucket edge leaning on the ground (see
picture) when digging and shoveling material on flat
ground. Be careful not to fasten the load to one side
which will cause unbalance. This operation should be
