Operation
28 / 50
EN-US · 30.30.01.01610 · 00 · 01/20
7.1.6 Checks before Starting Work
1. Ensure that the energy supply is operating reliably.
2. Inspect safety features.
3. Drain the water separator (optional).
7.2 Adjusting the Position of the Suction Plates
8
11.1
11
6.2
6
6.1
6
Suction plate
6.1
Clamping lever for suction plate
6.2
Suction plate holder
8
Main beam with vacuum distributor
11
Cross beam
11.1
Clamping lever for cross beam
Adjust the cross beams (11) and the suction plates (6) so that the load’s center of gravity is below the sus-
pension point:
1. Open the clamping lever (6.1 / 11.1) by approximately one full turn.
2. Adjust the cross beam (11) or suction plate holder (6.2) to the desired distance.
3. Close the clamping lever (6.1 / 11.1) all the way.
4. Check the vacuum connections.
7.3 Adjusting the Beam for Non-Rigid Loads
Lifting devices with more than two cross beams are often used for non-rigid loads with large dimensions,
e.g. thin metal sheets.
WARNING
Incorrectly adjusted beams
Risk of injury caused by insufficient lift capacity
4
Adjust the beam system so that all suction plates are on the same level when suction is
applied.
