sauter equitherm EQJW245, Руководство по эксплуатации

Страница: 22 / 127

22/127 www.sauter-controls.com
EQJW245
Commissioning
Parameter Description Range
Step
value
SP38 1.4 Slope of heating characteristic for heating 1 in K/K
0.2 to
5.0
0.1
SP60 0
Screed curing for heating 1
0 = not active
7d = Function heating performed for HK1
25°C = Ready-for-laying heating performed for HK1
8 = Function aborted
9 = Function successfully completed
0; 7d;
25°C;
8; 9 0; 7d;
25°C;
8; 9
SP208 40 Proportional band PI – actuator 2 control in K
2 to
1000
1
SP210 180 Actuator 2 run-time in seconds
30 to
960
15
SP211 5 Minimum T
F
limit for heating 2 in °C 5 to 100 1
SP212 75 Maximum T
F
limit for heating 2 in °C
20 to
150
1
SP215 1.2 Slope of heating characteristic for heating 2 K/K
0.2 to
5.0
0.1
SP260 0
Screed curing for heating 1
0 = not active
7d = Function heating performed for HK2
25°C = Ready-for-laying heating performed for HK2
8 = Function aborted
9 = Function successfully completed
0; 7d;
25°C;
8; 9 0; 7d;
25°C;
8; 9
SERVice-Parameter Tab.1
An overview of the SERVice parameters and explanations for individual SERVice
parameters is given in these sections: ‚List of SERVice parameters‘ and
‚Explanations for individual SERVice parameters‘.
3.3 SERVice level
In SERVice level, a specialist can adapt the basic setting of the EQJW245 to the
installation so as to meet specifi c requirements. For this purpose, also please
note the installation instructions enclosed with the EQJW245 (P 10 0001471).
Incorrect parameterisation (setting) of the heating controller
It can cause major faults on the installation, injuries to people or damage to the
installation.
SERVice mode must only be enabled by a specialist.
Some of the parameters cannot be changed - they can only be viewed (version
number, status information).
Access to SERVice level 3.3.1
In order to access the SERVice level, the bottom rotary switch must fi rst be
moved to one of the following positions (see chapter 4.1):
NOTICE