Sartorius MC 210 S, Инструкция по установке и эксплуатации, Страница: 97 / 188

Procedures for the Individual Weighing Mode
Tare Weighing
Symbol displayed:
Net
Key identified by:
●
-
F
Press the
F
key identified on the display by “
●
” to accept and store a weight
as the tare value. The tare weight will be stored only if the balance has stabilized.
At this point, the balance display is zeroed. After tare weighing, the net weight
of a sample is determined. The ID code of
F
in the display changes from “
●
”
to “STO.” Afterwards, weighing can be done starting from “zero.”
The tare weighing mode can be turned off by setting the appropriate menu code:
Weighing sequence Code
For MC 210 S, For MC 5 (-0CE),
MC 210 P, SC 2 (-0CE)
MC 410 S (-0CE) and MC 21 S
Off 3 8 1* 3 7 1
On 3 8 2 3 7 2*
Weighing-in
Key identified by: STO -
F
The stable net weight displayed is stored when you press
F
identified
on the display by “STO.”
Backweighing
Key identified by: RE S -
F
Key identification when a value is stored: RE S v -
F
The stable backweighed sample, the residue, is stored when you press
F
identified on the display by “RE S.”
By setting the appropriate codes in the balance operating menu, you can select
the display modes for two calculated values. Use the
w
key to toggle
between these two values. The first difference calculated between the net initial
sample weight and the residue is automatically displayed. In the display
modes “residue in the specified weight unit” and “residue in percent,” the “Net”
symbol indicates that the tare value was subtracted.
At the same time, the identification code shown on the display for the
F
key
changes to “RES v ” to indicate that a value has been stored in the particular memory.
* = factory setting
3–19