Sartorius MC 210 S, Инструкция по установке и эксплуатации

Страница: 69 / 188

Fully Automatic Draft Shield Function
You can define the fully automatic draft shield function to meet the most diverse
requirements. After you have pressed a function key (or after a control command
has been received – see part 4, “Interface Description”), the draft shield will close
automatically and the balance will then perform the particular function activated
by the key. If code 8 8 2 or 8 8 3 is set, the draft shield will open once the
function selected has been performed. In addition, when codes 8 8 2 through
8 8 5 are set, the draft shield closes automatically if the balance has not been
used for more than one minute.
To be on the safe side for automatic operation of the balance with a robot, you
should turn off the fully automatic draft shield function (code 8 8 1).
The draft shield status should always be polled for operation with a robot
(see part 4, “Interface Description”).
The draft shield operates automatically for the following functions:
– powering on the balance (
e
key)
– taring once the balance has stabilized (
t
key)
– printing on request after stability (
p
key)
– starting all calibration functions (
f
key)
– using the tare memory once the balance has stabilized (
f
key) –
see also part 3, “Application Programs”
– storing weights during differential weighing and backweighing, weighing in
percent and counting (
F
key) – see also part 3, “Application Programs”
– storing weights during over/under checkweighing (
f
key) –
see also part 3, “Application Programs”
2–23