Sartorius MC 210 S, Инструкция по установке и эксплуатации, Страница: 136 / 188

Counting with Additional Requirements
Changing the Reference Sample Quantity
You can change the reference sample quantity as required:
– Enter the reference sample quantity (piece count) using the numeric keys and store
it with
F
identified by “STO REF”
or
– Change it in the parameter mode
To select the parameter mode: – Hold down
i
for more than 2 seconds
To change the setting: – Use
f
identified by “^”
If you enter a wrong number, press
c
to clear it
To store the reference quantity
– temporarily until you turn off
the power: – briefly press STO -
F
– permanently after you turn off
the power (in the non-volatile
memory):
– press STO -
F
for more than 2 seconds
This setting is not cancelled by the reset code 9 – – 1°!
Reference Sample Quantity
Changing the reference sample quantity Code
No change 2 3 1
In cycles: 5, 10, 20, 50, 100, 5, 10, ... 2 3 2*
In increments of one 2 3 3
Storage Parameter for the Reference Sample Weight
(Code only for models MC 210 S (-0CE), MC 210 P (-0CE), MC 410 S (-0CE))
The weight is stored Code
with full accuracy according to the internal resolution 3 5 1
according to the display accuracy 3 5 2*
* = factory setting
3–58