20
VACUUM SYSTEM
The high speed centrifugal vacuum
31
is designed to use 4" hose
only. The vacuum is belt driven through an electro-magnetic clutch
19
so that the vacuum can be off during open blow operations.
Make sure that the material deceleration box and exit transitions are
mounted. Use the following steps for starting the vacuum system.
1.
With PTO disengaged, turn on the master switch
4
and then
the vacuum clutch switch
22
.
2.
Connect vacuum hose and spray hose when ready to start job.
3.
Engage the truck mounted PTO box at a low idle.
4.
Idle the truck up to the correct range established
during installation.
VACUUM CLUTCH WARNING: Upon completion of the sidewall
spray operation, the vacuum can be switched off while the
PTO is still engaged. Make sure that the job is complete.
Any engagement of the clutch while the PTO is engaged will
result in premature wear of the armature in the clutch assembly.
Additionally, the vacuum switch is wired through the master
switch so that the vacuum switch would not be left on accidentally.
This could drain the truck battery down overnight causing the
clutch to slip or not function at all.
GENERATOR
The generator
18
supplies 120 volt power on the machine
whenever the truck mounted PTO box is engaged and rpm
is increased to programmed speed. Refer to manufacturer’s
literature for any information concerning use of the generator.
WARNING: Always make sure that any device (stud scrubber,
light, etc.) Plugged into the generator is off when the truck
PTO controls are engaged or disengaged. This will prevent low
voltage output which could damage the generator.
WATER PUMP
The water pump
16
supplies water on the machine whenever
the truck mounted PTO box is engaged. Refer to manufacturer’s
literature for plumbing to a water source. During winter operations,
the pump foot
33
will slide out of the pump mount
34
. Roll off
the link belts and remove all water line connections and store
inside until the next time the pump is needed.
31
22
19
18
34
33
16
Содержание CertainTeed Volu-Matic 500
