SAINT-GOBAIN CertainTeed Volu-Matic 500, Руководство по эксплуатации и информация по безопасности

Страница: 28 / 62

28
5. Remove the bolts that hold the backing plate H and seal I to the rotor
assembly. Clean the rotor vane surface before placing in a new seal.
Bolt on backing plate making sure not to over tighten distorting the seal.
6. Apply spray silicon to edges of new rubber seals and surface of feeder
barrel. Apply never-seize lube on inlet bearing race.
7. Insert rotor assembly into feeder barrel rotating counterclockwise using
crank hub J and rod K while pushing with free hand. Make sure bearing
felt at inlet end plate does not pinch between rotor shaft and bearing race.
8. Once rotor shaft enters the inlet bearing, it may be necessary to use a
dead blow soft hammer to fit rotor all the way in the feeder while rotating.
Push rotor as far in as possible with seals beginning to bend over on the
side against the inlet end plate.
9. Drive roll pins into end plate before sliding on rotor shaft. Align to existing
holes and hammer in, use vise grip pliers to draw end plate up to rubber
seals. Install mounting bolts and tighten half way down - rotate rotor -
tighten bolts – rotate rotor - tighten bolts completely - rotate rotor. Peer
through outlet end plate to see if rubber seals break over against end plates
evenly - adjust as required by rotating rotor and tap with dead blow
hammer. Tighten set screws in bearing collars when rotor is centered.
Install drive components and any guards removed. Discard old seals.
H
I
J
K