SAINT-GOBAIN CertainTeed Volu-Matic 500, Руководство по эксплуатации и информация по безопасности

Страница: 17 / 62

17
26
WARNING: Recommended hose size, type, and length must be used to achieve maximum results.
CTMW cannot guarantee performance of the Volu-Matic 500 machine if hoses are undersized or
worn or damaged or hoses other than those recommended are used.
Repeated warnings about choice of hose may seem to be an attempt
to sell our brands, but we must stress the importance of proper hose
selection for the type material and operation. A rough bore corrugated
hose is necessary for blown fibers since smooth bore rubber or plastic
will roll shredded material into small tight balls. Your
Volu-Matic 500
machine has been engineered, when properly adjusted, to condition
fibers for optimum coverage. Improper hose selection will degrade
fibers conditioned by the machine and reduce insulation value in
blown material. Do not deviate from hose diameters, types, or length
as specified in the table.
LOADING
The operator loads the machine hopper from a standing
position on the floor depositing bags of material on the drop
gate
26
. Pull the drop gate sharply toward you to lay down
for loading and then deposit the material into the hopper.
Do not build scaffolding or use a foot stool to load material
into the
Volu-Matic 500
machine. This moves the operator
closer to the rotating components in the hopper and
provides a way to lose balance and fall.
Load three to four bags of material into the hopper being
particularly careful not to leave pieces of bag in the material
since this will clog and stall the machine. Make sure to keep
the hopper full during operation but do not overload
preventing material from overflowing onto the truck floor.
WARNING: DO NOT attempt to remove any foreign object from the machine until it is completely shut
down; master switch turned off, remote cord unplugged, and the PTO disengaged. Failure to do so will
result in serious injuries by the rotating components in the hopper.
THIS
NOT
THIS