SAINT-GOBAIN CertainTeed Volu-Matic 500, Руководство по эксплуатации и информация по безопасности

Страница: 30 / 62

30
4. Bend right side of rubber toward angle toe and shove seal to right,
bend left side of rubber toward angle toe as shown by hand.
5. Lift right side of seal assembly up.
6.
Rotate front face of seal assembly up.
7. Slide seal assembly into feeder housing aligning center hole in the angle
toe of the seal assembly with the alignment pin.
8. Once the seal assembly has been inserted all the way to the rotor, add
Loctite to the threads of the attach bolts G . Insert attach bolts with lock
washers in end holes and tighten.
9. Remove alignment pin and insert remaining bolts, apply thread Loctite
and use lock washers. Repeat steps two through nine to replace all seals.
Inspect that felt strips (see arrows) will seal the door.
10. Once all seals are replaced, insert door against top stop as shown.
Shove bottom of door down to shelf and then push door straight in to
align bolt holes. Bolt door securely in place and insert alignment pin
into top handle of door for future seal changes, discard old seals