25
GENERAL
Make sure all power is off and the truck mounted PTO controls are disengaged before attempting any
maintenance procedures. The only exception is the blower relief valve which requires no entrance into the
machine. Check for loose nuts and bolts, check for slack and condition of chains and belts, and check for oil
leaks especially after the fi rst few days of operation. Check the condition of the blowing hose and vacuum
hose and for any build up of material. Keep the machine clean.
DAILY
1.
Empty the hopper and blowing hose completely at the end
of each day.
2.
Clean the spray nozzle of any material build up.
3.
Check and clean the blower air inlet truck fl ange
37
,
and as required during operation. Keep these screens clean.
4.
Visually inspect and remove any foreign objects that may have entered the machine, such as; pieces of
bag, rags, etc.
5.
Make sure the emergency stop buttons
A
&
B
and the swing gate safety
2
switches are functional.
WEEKLY
1.
Check for slack and condition of the PTO drive belts from under
the truck. Keep a spare set on hand in case of damage.
2.
Visually inspect shredder hammers for tip wear through access
window
38
. Window may be removed to clear blockages occurring
in this area.
3.
Very important
– grease the PTO drive pillow block bearings
39
no more than 2 pumps from a hand operated gun.
4.
Very important
– grease the PTO drive pillow block bearings
40
no more than 2 pumps from a hand operated gun.
37
38
39
40
Содержание CertainTeed Volu-Matic 500
