SAINT-GOBAIN CertainTeed Volu-Matic 500, Руководство по эксплуатации и информация по безопасности

Страница: 27 / 62

27
CHANGE THE VOLU-MATIC™ 500 STANDARD AIRLOCK FEEDER SEALS AS FOLLOWS:
• Make sure you have a complete set of seals (six) before the job is started.
• Make sure all power is disconnected; distributor wire on engine, PTO disengaged, master switch off,
remote cord unplugged, etc.
• Remove necessary guards to do the job after power is disconnected, be sure that all guards are installed
and secure when job is complete.
• Once the outlet end plate is removed, check for excessive wear on the feeder barrel and end plate
surfaces. New seals will not be effective in an excessively worn feeder. Inspect rotor for any wear and
repair as required.
• Replace excessively worn or damaged feeder barrel and/or end plates and bearing felt seals for optimum
performance from your Volu-Matic 500 machine. Excessively worn parts are considered to be when 25%
of metal thickness has worn away, see replace the feeder end plates
• Supplies and tools for seal change:
- set of seals (P/N 210903) STD Feeder
- spare 1/4"-20 x 5/8" length grade five bolts and lock washers
- spray silicon, never-seize shaft lube, penetrating oil, emery cloth,
- feeder crank hub and rod, dead blow hammer, small punch and ball peen
- hammer, vice grip pliers, pry bars, flat file, miscellaneous sockets and
- open end wrenches, miscellaneous hex head allen wrenches
1. Remove drive chain A and chain idler assembly C .
2. Loosen set screws in the bearing collar D on the inlet end plate only.
3. Remove mounting bolts in outlet end plate E and drive roll pins F out
of feeder assembly.
4. Use pry bars between end plate and feeder barrel to bring entire rotor
assembly out. Clean, file, and polish rotor shaft G . Loosen set screws
in bearing collar and slide end plate off rotor shaft.
A
B
C
D
E
F
G