SAINT-GOBAIN CertainTeed Volu-Matic 500, Руководство по эксплуатации и информация по безопасности

Страница: 26 / 62

26
5. Very important – grease the vacuum fan flanged bearings 41
no more than 2 pumps from a hand operated gun.
6.
Clean out any material build up inside the vacuum housing
31
.
7. Check the oil level in the blower.
8. Check the oil level in the gearbox(s).
9. Check the oil level in the transmission.
10.
Check the oil level in the water pump.
11. Grease the shredder drive belts flat face idler 42 no more
than 1 pump from a hand operated grease gun.
12. Check blower relief valve 43 function.
13. Check chain and belt tension, adjust as required.
AIRLOCK FEEDER
The airlock feeder will require periodic maintenance to prolong the
life of the assembly since steel will wear when abrasive type materials
and air velocity are mixed. Feeder seals must be changed every
250 hours of operation or approximately every 1-1/2 months if the
Volu-Matic 500 machine is operated 8 hours a day 5 days a week,
or sooner depending upon the type of material. Failure to change
seals on schedule will result in excessive wear and replacement of
the feeder assembly.
41
31
42
43