SAINT-GOBAIN CertainTeed Volu-Matic 500, Руководство по эксплуатации и информация по безопасности

Страница: 29 / 62

29
CHANGE THE VOLU-MATIC 500 FRONT DOOR QUICK CHANGE AIRLOCK FEEDER
SEALS AS FOLLOWS:
• Make sure you have a complete set of seals (six) before the job is started.
• Make sure all power is disconnected; distributor wire on engine, PTO disengaged, Master switch off,
remote cord unplugged, etc
• Remove necessary guards to do the job after power is disconnected, be sure that all guards are installed
and secure when job is complete.
• Once the door on the feeder is removed, check for excessive wear on the feeder barrel and end plate
surfaces. New seals will not be effective in an excessively worn feeder. A thorough inspection will require
removal of all seals before installing a new set.
• Replace excessively worn or damaged feeder barrel and/or end plates and rotor shaft felt seals for
optimum performance from your Volu-Matic 500 machine. Excessively worn parts are considered to be
when 25% of metal thickness has worn away, see ‘Replace the Feeder End Plates’ section.
• Supplies and tools for seal change:
- set of seals (P/N 210009) Quick Change Feeder
- spare 3/8"-16 x 1" length grade eight bolts
- thread Loctite
- spray silicon
- ratchet and 8" extension
- 9/16" socket and wrench
- medium standard screwdriver
- miscellaneous wrenches for guard removal
- feeder crank assembly (P/N 209872)
- centering tool (P/N 210019)
- centering tool spacer (P/N 211192)
1.
Remove the side access door
A
from the feeder assembly
B
by removing the four bolts and then pull on the handles.
2. Rotate rotor C by hand using belts D that drive the shredder hammers
in the same direction as the arrow, the transmission has to be in gear.
Rotate the rotor so that the seal ends up in the center of door opening.
Remove all attach bolts, push one side of seal forward and bring the
other side of the seal out of the feeder housing on an angle. Insert
seal alignment pin
E into the center hole of bolt hole pattern in rotor.
3. Spray silicon on side edges of feeder opening. Make sure to install each seal
in the same direction as removed - angle toe of assembly facing in opposite
direction of rotation. Place new seal assembly
F as shown.
A
B
D
C
E
F