SAINT-GOBAIN CertainTeed Volu-Matic 500, Руководство по эксплуатации и информация по безопасности

Страница: 13 / 62

13
PRELIMINARY CHECKS
1. If your machine was shipped, remove all crating from machine frame. The skids should be removed when the
machine is located in the contractor’s truck or other form of transportation.
2. Be sure that the hopper area is free of loose objects.
3. Check that chain and belt drives are clear of loose
objects and that the drives are adequately tensioned.
4. Check for components that may have vibrated loose, such as;
airstream connections, wiring connections, bearings, guards, etc.
5. Check the oil levels in the blower 10 , right angle gearboxes 11 , and the transmission 12 . When checking the oil
in the blower, turn the brass valve 13 90 degrees to check, a small amount should appear indicating sufficient
oil. Refer to the maintenance section for capacities and type of oil to use for each component.
6. Open the material conditioning slide 14 to the number 18 position, fully open. See the operation section
under slide gate control.
7. Make sure that the air bleed control valve 15 is fully closed. The pointer should face the closed label.
See operation section under air bleed system.
8. Make sure the master switch 4 is off and that the remote cord is not plugged into the receptacle 5 .
9. Close and secure any open guards
PARTIAL VIEW OF
HOPPER AREA
11
12
15
10
10
13
IN THIS PICTURE, THE VALVE IS AT THE
OPEN POSITION. ALWAYS START AT THE
CLOSED POSITION