rotork CML-100, Инструкция по установке и обслуживанию

Страница: 10 / 60

A4 US
US
A4
US A4
US
A4
10
hazardous Area Approvals
special Conditions for safe use (ATeX & IeCex approved actuators)
In accordance with clause 5.1 of IEC/EN 60079-1, the critical dimensions of the flamepaths are:
CML-100/250
Flamepath Maximum Gap (mm) Maximum Width L (mm)
Lid/base 0.15 12.8
Base/pinion shaft 0.145 13.5
Base/feedback shaft bush -0.02 13.7
Feedback shaft bush/feedback shaft 0.06 13.7
Handknob shaft/lid 0.1 25.9
CMQ-250/500
Flamepath Maximum Gap (mm) Maximum Width L (mm)
Lid/base 0.15 12.8
Base/pinion shaft 0.235 29.8
Base/feedback shaft bush -0.02 13.7
Feedback shaft bush/feedback shaft 0.06 13.7
Handknob shaft/lid 0.1 25.9
CMR-50/100/200
Flamepath Maximum Gap (mm) Maximum Width L (mm)
Lid/base 0.15 12.8
Base/pinion shaft 0.235 29.8
Base/output shaft 0.145 12.8
Handknob shaft/lid 0.1 25.9
CML-750
Flamepath Maximum Gap (mm) Maximum Width L (mm)
Lid/base 0.15 12.8
Base/pinion shaft 0.235 37.3
Base/feedback shaft bush -0.02 13.7
Feedback shaft bush/feedback shaft 0.06 13.7
Handknob shaft/lid 0.1 25.9
CMQ-1000
Flamepath Maximum Gap (mm) Maximum Width L (mm)
Lid/base 0.15 12.8
Base/pinion shaft 0.235 37.3
Base/feedback shaft bush -0.02 13.7
Feedback shaft bush/feedback shaft 0.06 13.7
Handknob shaft/lid 0.1 25.9
CMR-125/250
Flamepath Maximum Gap (mm) Maximum Width L (mm)
Lid/base 0.15 12.8
Base/pinion shaft 0.235 37.3
Base/ourtput shaft 0.145 13
Handknob shaft/lid 0.1 25.9
Note: Negative Sign denotes an interference fit.
wARnIng
The equipment utilises a non-metallic outer coating
and has a potential static hazard. Clean only with a
damp cloth.