ROPA Tiger 5, Перевод оригинального руководства по эксплуатации

Страница: 409 / 530

Maintenance and Service
Lifter
409 / 530
Removing the PR2h lifter roller
– Separate the counter bearing of the lifting roller concerned on the right side of the
device from central lubrication.
– Remove the cover cap of this bearing and loosen the adjusting ring of the bearing.
– Unscrew the bearing housing from the lifter.
– The 6th lifting roller can now be detached from the lifter gears.
– To dismantle 1-5 lifting rollers, each two driven in one another lock pins ( 1 ) must
still be taken off with the provided special pin punch.
– To remove the 5th lifting roller, the lifter gears right on the gear suspension must be
loosened (two clamping bolts ( 2 )), the lever ( 3 ) removed and the gears pushed out-
wards for about 80 mm.
This work can be made significantly easier with the special ROPA tool item no. 018549
(pull-off device).
ADVICE
The 5th lifting roller is secured on both sides with two lock pins ( 1 ) each, which are
pushed in from opposite sides.
– The 5th lifting roller can be removed.
(2) Clamping bolts
(3) Lever
Mounting lifting rollers
Grease amply the polyamide coupling before the lifting roller is pushed in. Insert the
new lifting roller with screwed-in polyamide coupling into the claw coupling on the
drive shaft on the lifter gears to the stop. The lock pins must be driven in for the 1st to
5th. Remember to put in two lock pins at the 5th lifting roller on the both ends.
Mount the counter bearing completely at the lifter.
In any case, close all open lock pin holes using original Ropa plastic plugs (ROPA
item no. 122803) to avoid ingress of dirt.