ROJ PCS 200, Оригинальное руководство пользователя

Страница: 21 / 112

Installation
PCS 200 Kit - 2 .1 -
2 - INSTALLATION
2.1 DMD0 e DMD2 (MD) GEARED MOTORS FEATURES
For further information, please refer to the following enclosed documents for the
DMD0:
•
TD_1406.601_revD.pdf or later revision.
•
1061_hard.pdf
•
1061-cid-a.pdf
•
1061_angle.pdf
For the DMD2:
•
TD_DMD2_revI.pdf o later review.
2.2 MOTORS (MD) INSTALLATION
2.2.1 General principles
The fastening of motors to the machine, whether they are used for the seeding disc
shaft or the fertilizer or micro-granular distributor shaft rotation, must be carried out in
a way as to ensure a perfectly aligned coupling between the disk/distributor shaft and
the reducer outlet hollow shaft.
In the absence of a perfect alignment, radial forces may occur on the
bearings, causing an increase of the necessary torques and a reduction of
the device life.
In order to relieve tension on the bearings, it is possible to use rubber
bushes supplied with the motor and / or an elastic joint. This one is not
supplied with the motor kit and it must be chosen and dimensioned
according to the application.
2.3 DMD0
2.3.1 Outlet shaft torque and speed
The following features refer to the geared motor outlet shaft (slow shaft) dimensions.
Nominal torque 8.75Nm
Peak torque
19Nm (single pulse, duration 500ms)
12Nm (repetitive, duration 500ms, every 5 second)
Nominal
speed
100 rpm