User Manual
PCS 200 Kit
- 3.45 -
ECI software update
Path:
Selecting the desired software from the list and pressing the
1
button, it is possible
to update the ECU software.
Remarks:
1.
After the ECU software update it is possible that an
“
Invalid protocol version
”
error is displayed. In that case, just go on with the updating procedure: the
error is deleted after the HMI has been updated too.
2.
After the ECU software update, it is possible that one ore more errors are
displayed according to the previously installed software version, as follows:
Configuration and setup parameters lost
Invalid configuration or MD address
Data checksum
Invalid checksum
In that case, follow the procedure described in the next paragraph in order
to confirm the addressing and to restore the parameters.
How to confirm the addressing and restore parameters
1.
Close the alarms window via the green check mark. The
“
MD Addressing
”
opens.
2.
Wait 10 seconds before pressing the
“
Addressing
”
button.
1
Содержание PCS 200
