Basic Instrument Functions
R&S
®
CMW500
95
User Manual 1173.9463.02 ─ 02
subnet mask 255.255.0.0) must not be changed. For test setup details, refer to the
"Data Application Unit" user manual.
SCPI command:
SYSTem:COMMunicate:NET:...
See
Data Appl. Control
If a Data Application Unit (DAU) is installed, "Go to config" opens the "Data Application
Control" dialog which lets you configure data testing IP services of the DAU. For more
details, refer to the "Data Application Unit" user manual.
SCPI command:
n/a
Software Update
The Device Group must match the settings in the "R&S Software Distributor" in order to
perform a remote software update, see
.
SCPI command:
User Mode
The user mode can be changed using the softkey "User Mode Login". The "User" mode
provides the complete measurement functionality of the R&S CMW500 and most selft-
ests. The "User (Extended)" mode provides additional RAM and cable tests; see e.g.
on page 104. The remaining user modes are for service purposes.
SCPI command:
n/a
5.3.2 Remote Settings
The "Remote" section of the "Setup" dialog lists all available interface and protocol types
for remote control of the instrument and their parameters.
The highest level lists the interface and protocol types:
●
VXI-11 (LAN connector, VXI-11 protocol)
●
IEC (GPIB bus interface, option R&S CMW-B612A or R&S CMW-B612B)
●
USB2 ("USB Remote" connector)
●
TCPIP (LAN connector, VISA socket resource)
For remote control via LAN it is recommended to use "VXI-11", not "TCPIP".
The entries at the second level correspond to one remote channel each. Each channel
is dedicated to one sub-instrument, see
Assigned Instrument (all protocol types)
. Several
channels can be used in parallel. The number of available channels depends on the
protocol type and on the installed options.
See also:
Multiple Channels for Remote Access
To open the dialog press SETUP and select "Remote".
Setup Dialog
