Using the EDP Port
6-19
Table 6-3. (continued)
ID REFERENCE COMMANDS
“RT”
(RECALL TARE REGISTER COMMAND)
“XT”
(XMIT TARE COMMAND)
“XTG”
(XMIT TARGET COMMAND)
“XO”
(XMIT OVER COMMAND)
[SP]
is the ASCII character for space (20 Hex).
[UNITS]
is the 1–2 character indication of the current unit of
measure:
kg
for kilograms
g
for grams
lb
for pounds
oz
for ounces
lb/oz use special format
[EOL]
is either [CR] or [CR][LF], depending on serial port setting
for End of Line Termination.
“CT” (CLEAR TARE COMMAND)
This sequence requests the CW-80 to Clear the Tare value associated with the
ID specified in the Location character field. The CW-80 acknowledges when
successful with the Acknowledgement Character sequence [“*”][EOL] if
enabled.
“CTG” (CLEAR TARGET COMMAND)
This sequence requests the CW-80 to Clear the Target value associated with the
ID specified in the Location character field. The CW-80 acknowledges when
successful with the Acknowledgement Character sequence [“*”][EOL] if
enabled.
“CO” (CLEAR OVER COMMAND)
This sequence requests the CW-80 to Clear the Over value associated with the
ID specified in the Location character field. The CW-80 acknowledges when
successful with the Acknowledgement Character sequence [“*”][EOL] if
enabled.
“CU” (CLEAR UNDER COMMAND)
This sequence requests the CW-80 to Clear the Under value associated with the
ID specified in the Location character field. The CW-80 acknowledges when
successful with the Acknowledgement Character sequence [“*”][EOL] if
enabled.
