Introduction
1-5
ID
Table 1-3. (continued)
OVER
UNDER
TARGET
Note:
See the Accept bar graph LED
on the front panel (Figure 1-1).
Note:
See the Under bar graph LEDs
on the front panel (Figure 1-1).
Note:
See the Over bar graph LEDs on
the front panel (Figure 1-1).
OVER key/UP ARROW key
OVER key
The OVER key allows the display of the current “Over tolerance” value,
or allows setting the Over tolerance” value. See “Displaying/Setting
Over/Under/Tare Values”. As a secondary function, the OVER key also
acts as an Up Arrow key while in the Configuration mode.
UP ARROW key
When in the SET mode, or when selecting an ID number, pressing this
key establishes an upward direction for modifying the value. When in
the Configuration mode, the Up Arrow key moves “up” one level in the
Configuration menu tree, locking in the value displayed.
UNDER key/DOWN ARROW key
UNDER key
The UNDER key allows the display of the current “Under tolerance”
value, or allows setting the current “Under tolerance” value. As a
secondary function, the UNDER key will also act as an Down Arrow
key while in the Configuration mode.
DOWN ARROW key
When in the SET mode, or when selecting an ID number, pressing this
key establishes a downward direction for modifying the value. When in
the Configuration mode, the Down Arrow key moves “down” one level
in the Configuration menu tree, allowing you to view a current param-
eter setting.
TARGET key
When the CW-80 is set up in Target mode, the TARGET key is used to
acquire a weight value from the platter, and assign it as the desired
“Target” value. The CW-80 then computes the Under and Over values
based on predetermined tolerance settings defined during configuration.
LEFT ARROW key
As a secondary function, the TARGET key also acts as a Left Arrow
key when navigating through the Configuration menu tree. When used in
the Configuration mode, the TARGET key moves “to the left” one
position within the Configuration menu tree, allowing you to view other
parameter choices on the same level.
ID key
The ID key is used to select a particular Over/Under/Tare/Units register
set to be retrieved, altered, saved, used, etc.
RIGHT ARROW key
As a secondary function, the ID key also acts as Right Arrow key when
navigating through the Configuration menu tree. When used in the
Configuration mode, the ID key moves “to the right” one position within
the Configuration menu tree, allowing you to view other parameter
choices on the same level.
