Regal 42 Fly-Grande Coupe, Руководство пользователя

Страница: 124 / 386

71
Systems
For general knowledge all red water tubing supplies the
“hot” water on board your vessel. Likewise, all blue wa-
ter tubing supplies the “cold” water.
Note that the system is normally winterized from the
factory utilizing a product called “Freeze Ban”. It is
best to completely drain the Freeze Ban before adding
any water to the tank in order to minimize the taste of
Freeze Ban. Freeze Ban will not harm you but it does
have a peculiar taste.
Th
e system requires little maintenance except occasional
fl ushing of the tank, cleaning of the water fi lter and
winterizing in cold weather climates.
For more specific information on the water system
contact your closest Regal yacht dealer.
Note: To completely turn vessel water off :
1. At mooring with the standard dockside water inlet
valve connected turn the marina faucet off . Disconnect
the dockside water inlet hose. Reinstall the dockside wa-
ter valve cap.
2. At sea deactivate the pressure water system breaker at
the ship’s main DC electrical panel.
POSSIBLE PROBLEMS/SOLUTIONS-
FRESH WATER SYSTEM
1. Fresh water pressure pump cycles on
and off . Normally this type of action in-
dicates a water leak in the system. Check
all fresh water system related equipment
on the deck, cabin, and engine compart-
ment for leaks. Do not forget wash down
equipment including spigots. Look for puddled or drip-
ping water.
2. Using potable water system the water pressure is
weak. Check the fresh water pressure pump fi lter for
debris. Also, make sure the potable water tank level is
suffi
cient at the salon monitor.
3. Water at sink or shower is hammering and has air
bubbles in it. Check for air leaks in the system along
with low water levels in the potable water tank.
4. Water is backing up in the shower. Find the correct
shower sump pump. If it is full of water even when run-
ning there normally is a clog at the pump screen. Clean
as needed.
5.
Th ere is no water at any of the fresh water related
equipment such as faucets, showers and wash downs.
Check to make sure the fresh water pressure pump
breaker is on. Also, check the fresh water monitor for
tank levels at the salon control panel.
6. Th e water system has a bad odor. Use the fresh water
pressure pump to drain the fresh water system. Do not
drink the water as it may be contaminated. Sanitize the
water system as explained earlier in this chapter
7. Th ere is no hot water. Turn the hot water heater
breaker to the off position. Remove the back cover on
the water heater and check the reset button. Push to re-
set. Also, the heating element may of malfunctioned. At
this point, call a service technician.