Raytheon Anschütz AP02-S01, Руководство пользователя

Страница: 134 / 166

PILOTSTAR D
4--30
3060.DOC012
Edition: March 13, 2009
Press the
Rud
key until ”autotrim ...” appears in the line of text.
Press the key until optimal control behavior is achieved.
Make a heading change of 180

and check the heading behavior.
Press the
Rud
key until ”ex?=1” appears in the line of text.
When the key is pressed, the service menu is left; a previously changed
parameter setting is not stored.
If a new parameter value is to be stored, ”CONFIG. on/off” must be called up
(see #3).
5. On the navigation receiver, define a route of 3 way points and two legs.
Refer to the navigation receiver’s manufacturers manual regarding this operation.
Each leg of the route should be a minimum of 10 nautical miles in length.
The track course of first leg should be directly into the prevailing sea and wind.
The track course for second leg should be +/-- 90

of the first leg.
5.1 Steer the vessel as close as possible to the first way point using heading control
(angular range approx.

60

).
Press the
Track
key and the
Track
LED will now illuminate accompanied by the
red LED and an audible alarm will sound.
The text indication will read ”xte meter ...” for approximately 3 seconds and will
be replaced by ”NEW TRACK ...”. Pressing the key will accept the track
and write the track course to the ”SET HEADING” indication.
The SET HEADING indication will now retain the same value until the track has
been completed or superseded. Observe the track keeping ability of the pilot for a
minimum of 20 minutes. If the pilot does not stay close enough to the track line,
increase the ”TRACK <>” parameter until the vessel requirements are satisfied.