R&S ESU Series, Руководство по эксплуатации, Страница: 665 / 855

R&S ESU Remote Control – Description of Commands
STATus Subsystem
6.226 Operating Manual 1302.6163.12 - 03
6.18 STATus Subsystem
The STATus subsystem contains the commands for the status reporting system (see chapter “Remote
Control – Basics” , section “Status Reporting System” on page 5.18 ). *RST does not influence the status
registers.
STATus:OPERation[:EVENt]?
This command queries the contents of the EVENt section of the STATus:OPERation register. The
contents of the EVENt section are deleted after readout.
Example:
"STAT:OPER?"
Characteristics: *RST value: –
SCPI: conform
Mode: R, A
STATus:OPERation:CONDition?
This command queries the CONDition section of the STATus:OPERation register. Readout does not
delete the contents of the CONDition section. The value returned reflects the current hardware status.
Example:
"STAT:OPER:COND?"
Characteristics: *RST value: –
SCPI: conform
Mode: R, A
STATus:OPERation:ENABle 0 to 65535
This command sets the bits of the ENABle section of the STATus:OPERation register. The ENABle
register selectively enables the individual events of the associated EVENt section for the summary bit
in the status byte.
Example:
"STAT:OPER:ENAB 65535"
Characteristics: *RST value: –
SCPI: conform
Mode: R, A
STATus:OPERation:PTRansition 0 to 65535
This command sets the edge detectors of all bits of the STATus:OPERation register from 0 to 1 for the
transitions of the CONDition bit.
Example:
"STAT:OPER:PTR 65535"
Characteristics: *RST value: –
SCPI: conform
Mode: R, A