RAM Commercial ProMaster 2024, Руководство пользователя, Страница: 31 / 284

are programmed to the vehicle can be used to start and
operate the vehicle. The system will shut the engine off
in two seconds if an invalid key fob is used to start the
engine.
After placing the ignition switch in the ON/RUN position,
the Vehicle Security Light will turn on for three seconds
for a bulb check. If the light remains on after the bulb
check, it indicates that there is a problem with the elec-
tronics. In addition, if the light begins to flash after the
bulb check, it indicates that someone used an invalid
key fob to start the engine. Either of these conditions
will result in the engine being shut off after two
seconds.
If the Vehicle Security Light turns on during normal
vehicle operation (vehicle running for longer than
10 seconds), it indicates that there is a fault in the elec-
tronics. Should this occur, have the vehicle serviced as
soon as possible by an authorized dealer.
CAUTION!
The Sentry Key Immobilizer system is not compatible
with some aftermarket Remote Start systems. Use of
these systems may result in vehicle starting problems
and loss of security protection.
All of the key fobs provided with your new vehicle have
been programmed to the vehicle electronics
page 269.
NOTE:
A key fob that has not been programmed is also consid-
ered an invalid key.
IGNITION SWITCH
KEYLESS ENTER ‘N GO™ IGNITION
To activate the ignition switch the key fob must be
inside the passenger compartment within the first row
of seats.
The START/STOP ignition button has three operating
modes: OFF, ON/RUN, and START.
The push button ignition can be placed in the following
modes:
OFF
•
The engine is stopped
•
Some electrical devices (e.g. power locks, alarm,
etc.) are still available
ON/RUN
•
Driving position
•
All electrical devices are available (e.g. climate con-
trols, heated seats, etc.)
START
•
The engine will start (when foot is on the brake)
NOTE:
If the ignition switch does not change the mode by
pushing the button, the key fob may have a low or
depleted battery. In this situation, a backup method can
be used to operate the ignition switch. Put the nose
side (side opposite of the mechanical key) of the key
fob against the START/STOP ignition button and push to
operate the ignition switch.
WARNING!
•
When exiting the vehicle, always remove the key
fob from the vehicle and lock your vehicle.
•
Never leave children alone in a vehicle, or with
access to an unlocked vehicle.
•
Allowing children to be in a vehicle unattended is
dangerous for a number of reasons. A child or oth-
ers could be seriously or fatally injured. Children
should be warned not to touch the parking brake,
brake pedal or the gear selector.
(Continued)
START/STOP Ignition Button
Backup Starting Method
GETTING TO KNOW YOUR VEHICLE 29
2