RAM Commercial ProMaster 2024, Руководство пользователя, Страница: 128 / 284

Deactivation
The system can be deactivated under the following
conditions:
•
The speed of the vehicle is greater than 8 mph
(13 km/h).
•
The vehicle shifted into PARK.
•
The vehicle is in any gear other than REVERSE and
the touchscreen X button is pressed.
•
The camera delay system is turned off manually
through the Uconnect Settings
page 136.
NOTE:
•
If snow, ice, mud, or any foreign substance builds up
on the camera lenses, clean the lenses, rinse with
water, and dry with a soft cloth. Do not cover the
lenses.
•
If a malfunction with the system has occurred, see
an authorized dealer.
WARNING!
Drivers must be careful when backing up even when
using the Surround View Camera. Always check care-
fully behind your vehicle, and be sure to check for
pedestrians, animals, other vehicles, obstructions, or
blind spots before backing up. You are responsible for
the safety of your surroundings and must continue to
pay attention while backing up. Failure to do so can
result in serious injury or death.
CAUTION!
•
To avoid vehicle damage, Surround View should
only be used as a parking aid. The Surround View
camera is unable to view every obstacle or object
in your drive path.
•
To avoid vehicle damage, the vehicle must be
driven slowly when using Surround View to be able
to stop in time when an obstacle is seen. It is rec-
ommended that the driver look frequently over
his/her shoulder when using Surround View.
REFUELING THE VEHICLE
The gas cap is located behind the fuel filler door on the
left side of the vehicle. If the gas cap is lost or dam-
aged, be sure to use the correct replacement cap for
this vehicle.
1. Open the fuel filler door.
2. Remove the fuel cap by rotating it counterclockwise.
3. Fully insert the fuel nozzle into the filler pipe.
4. Fill the vehicle with fuel.
NOTE:
○
When the fuel nozzle “clicks” or shuts off, the
fuel tank is full.
○
Wait five seconds before removing the fuel
nozzle to allow excess fuel to drain from the
nozzle.
5. Remove the fuel nozzle, reinstall fuel cap and close
fuel filler door.
NOTE:
During fuel fill, nozzle position could affect the flow of
fuel. For best results, allow the nozzle to rest naturally
in the filler tube - do not raise the handle to increase
the fill angle.
WARNING!
•
Never have any smoking materials lit in or near the
vehicle when the fuel door is open or the tank is
being filled.
•
Never add fuel when the engine is running. This is
in violation of most state and federal fire regula-
tions and may cause the Malfunction Indicator
Light to turn on.
•
A fire may result if fuel is pumped into a portable
container that is inside of a vehicle. You could be
burned. Always place fuel containers on the
ground while filling.
Fuel Filler
126 STARTING AND OPERATING