RAM Commercial ProMaster 2024, Руководство пользователя, Страница: 197 / 284

Small punctures up to 1/4 inch (6 mm) in the tire tread
can be sealed with the Tire Service Kit. Foreign objects
(e.g., screws or nails) should not be removed from the
tire. The Tire Service Kit can be used in outside tem-
peratures down to approximately -4°F (-20°C).
This kit will provide a temporary tire seal, allowing you
to drive your vehicle up to 100 miles (160 km) with a
maximum speed of 50 mph (80 km/h).
Tire Service Kit Components And Operation
Using The Mode Select Knob And Hoses
Your Tire Service Kit is equipped with the following sym-
bols to indicate the air or sealant mode.
• Selecting Air Mode
Push in the Mode Select Knob and turn
to this position for air pump operation
only.
•
Selecting Sealant Mode
Push in the Mode Select Knob and turn
to this position to inject the Tire Service
Kit Sealant and to inflate the tire.
•
Using The Power Button
Push and release the Power Button once
to turn on the Tire Service Kit. Push and
release the Power Button again to turn
off the Tire Service Kit.
•
Using The Deflation Button
Push the Deflation Button to reduce the
air pressure in the tire if it becomes
overinflated.
Tire Service Kit Usage Precautions
•
Replace the Tire Service Kit Sealant Bottle prior to
the expiration date (printed at the lower right hand
corner on the bottle label) to assure optimum opera-
tion of the system. See the Sealant Bottle Replace-
ment in this section for further information.
•
The Sealant Bottle is a one tire application use and
needs to be replaced after each use. Always replace
these components immediately at your original
equipment vehicle dealer.
•
When the Tire Service Kit sealant is in a liquid form,
clean water, and a damp cloth will remove the mate-
rial from the vehicle or tire and wheel components.
Once the sealant dries, it can easily be peeled off
and properly discarded.
•
For optimum performance, make sure the valve
stem on the wheel is free of debris before connect-
ing the Tire Service Kit.
•
The Tire Service Kit Sealant is only intended to seal
punctures less than 1/4 inch (6 mm) diameter in
the tread/contact surface of your vehicle’s tires.
•
The Tire Service Kit Sealant is not intended to seal
punctures on the tires' side walls.
•
You can use the Tire Service Kit air pump to inflate
bicycle tires. The kit also comes with two needles,
located in the Accessory Storage Compartment (on
the bottom of the air pump) for inflating sport balls,
rafts, or similar inflatable items. However, use only
the Air Pump and make sure the Mode Select Knob
is in the Air Mode when inflating such items to avoid
injecting sealant into them.
•
Do not lift or carry the Tire Service Kit by the hoses.
WARNING!
•
Do not attempt to seal a tire on the side of the
vehicle closest to traffic. Pull far enough off the
road to avoid the danger of being hit when using
the Tire Service Kit.
•
Do not use Tire Service Kit or drive the vehicle
under the following circumstances:
○
If the puncture in the tire tread is approximately
1/4 inch (6 mm) or larger.
○
If the tire has any sidewall damage.
○
If the tire has any damage from driving with
extremely low tire pressure.
○
If the tire has any damage from driving on a flat
tire.
○
If the wheel has any damage.
○
If you are unsure of the condition of the tire or
the wheel.
•
Keep Tire Service Kit away from open flames or
heat source.
(Continued)
Tire Service Kit Components
1 — Sealant/Air Hose
2 — Hose Accessories
3 — Mode Select Knob
4 — Pressure Gauge
5 — Deflation Button
6 — Power Switch
7 — Sealant Bottle
8 — Power Plug
IN CASE OF EMERGENCY 195
7