RAM Commercial ProMaster 2024, Руководство пользователя, Страница: 103 / 284

•
When the automatic transmission is in PARK,
REVERSE or NEUTRAL
•
When the vehicle speed is below the minimum
speed range
•
When the brakes are overheated
•
When there is a stationary vehicle in front of your
vehicle in close proximity
•
When Electronic Stability Control (ESC) Full Off
mode is active
To Activate/Deactivate
Push and release the Adaptive Cruise Control (ACC)
on/off button. The ACC menu in the instrument cluster
display will read “ACC Ready.” Then proceed to setting
the desired speed as described in the next section.
To turn the system off, push and release the Adaptive
Cruise Control (ACC) on/off button again. At this time,
the system will turn off and the instrument cluster dis-
play will read “Adaptive Cruise Control (ACC) Off.” The
system will also turn off during any of the conditions
listed in “To Turn Off”
page 102.
WARNING!
Leaving the Adaptive Cruise Control (ACC) system on
when not in use is dangerous. You could accidentally
set the system or cause it to go faster than you want.
You could lose control and have a collision. Always
leave the system off when you are not using it.
To Set A Desired Speed
When the vehicle reaches the speed desired, push the
SET
(+)
button or the SET
(-)
button and release. The
instrument cluster display will show the set speed.
NOTE:
Fixed Speed Cruise Control can be used without ACC
enabled. To change between the different modes, push
the ACC on/off button which turns the ACC and the
Fixed Speed Cruise Control off. Pushing the Fixed
Speed Cruise Control on/off button will result in turning
on (changing to) Fixed Speed Cruise Control mode.
WARNING!
In Fixed Speed Cruise Control mode (ACC not
enabled), the system will not react to vehicles ahead.
In addition, the proximity warning does not activate
and no alarm will sound even if you are too close to
the vehicle ahead since neither the presence of the
vehicle ahead nor the vehicle-to-vehicle distance is
detected. Be sure to maintain a safe distance
between your vehicle and the vehicle ahead. Always
be aware which mode is selected.
If ACC is set when the vehicle speed is
below
20 mph
(32 km/h), the set speed will default to 20 mph
(32 km/h).
NOTE:
Fixed Speed Cruise Control cannot be set below
20 mph (32 km/h).
If either system is set when the vehicle speed is
above
20 mph (32 km/h), the set speed shall be the current
speed of the vehicle.
NOTE:
•
Keeping your foot on the accelerator pedal can
cause the vehicle to continue to accelerate beyond
the set speed. If this occurs, the Adaptive cruise
control light will flash and, if a target is detected by
the sensor, the target graphics will also flash.
•
If you continue to accelerate beyond the set speed
while ACC is enabled, the system will not be control-
ling the distance between your vehicle and the
vehicle ahead. The vehicle speed will only be deter-
mined by the position of the accelerator pedal.
Desired Driving Speed Through A
Detected Speed Sign
The Active Driving Assist (ADA) system allows the driver
to set the detected speed sign
page 106 as the
new desired driving speed. The Traffic Sign Assist (TSA)
system will suggest the new detected speed sign on the
cluster and then the driver can decide to confirm the
speed sign capturing by pressing the RES (resume)
button.
To Cancel
The following conditions cancel the ACC or Fixed Speed
Cruise Control systems:
•
The brake pedal is applied
•
The CANC (cancel) button is pushed
•
The Anti-Lock Brake System (ABS) activates
•
The gear selector is removed from the DRIVE
position
•
The Electronic Stability Control/Traction Control Sys-
tem (ESC/TCS) activates
•
The vehicle parking brake is applied
STARTING AND OPERATING 101
4