RADICAL DELTA CEP A, Руководство пользователя

Страница: 49 / 63

The following table provides information about the outputs of the MIDI2CV interface:
7.1 MIDI clock synchronization
The DELTA CEP A allows for synchronizing the LFOs, the timing of the effects (delay times
and modulation speeds) and the speed of the interpolator to a MIDI clock. The internal
clock, over the 'tapping' adjustable clock, is turned off as long as the unit receives a MIDI
clock and as soon as MIDI clock synchronization is enabled. The tap function is switched
off during MIDI synchronization. The settings for the MIDI clock are configured in the Utility
menu:
Setting up the MIDI channel for the MIDI2CV Interface
Button Knob/Button Description
- - - LEARN Hold down the [LEARN] button and press a key on the
connected MIDI keyboard to set the MIDI channel.
Ausgänge der MIDI2CV Sektion
Jack Description
GATE This output outputs a GATE signal whose length corresponds to the holding
time of the incoming MIDI note. Use this output, for example, to trigger and
control external envelope modules.
KB-CV This output produces a pitch control voltage with Volt/Octave ratio that
matches the received MIDI note.
CV
This CV voltage follows a MIDI controller, which you can set with the
[LEARN] button. Hold down the [LEARN] button and send the desired
controller from your keyboard, MIDI controller, or computer program to set
the assignment.
CLOCK
Here, the interface outputs the current system clock with an adjustable
prescaler. The current system clock depends on the settings and the
availability of internal or external clock sources. The system clock can run
independent with an onternal clock generator, with MIDI sync or with an
external analog clock signal.
RESET
When the DELTA CEP A receives a START command via MIDI, this output
will output a trigger signal to allow external sequencers to return to the start
position of the sequence.
Enable reception of MIDI synchronization data
Button Knob/Button Description
- - - SHIFT Hold down the [SHIFT] button to enter the utility menu. You
must hold the button until all LEDs 1-8 are lit blue. If you
release the [SHIFT] button afterwards, you have loaded the
utility menu.
- - - BIG KNOB Select the fourth submenu with the big knob. LED 4 lights up
green when selected.
- - -
DENSITY
Select the LED to the right of the [MORPH] BUTTON to select
the function for receiving MIDI Clock
von 49 63