RADICAL DELTA CEP A, Руководство пользователя

Страница: 21 / 63

3.2.1 Scale Quantizer
At the 1V/octave input the pitch of the Swarm Oscillator can be continuously adjusted. This
is a nice feature, especially in the experimental field. However, if you have to rely on
precisely dialing in a frequencym to reach the pitches of a particular scale, limiting that
freedom may make sense. Setting up an analogue step sequencer becomes a torment
- - -
DENSITY With the Density control you can set the number of oscillator
clones between 1 and 8.
SHIFT
FM-DEPTH The [SHIFT] key lets you use the DENSITY knob to control the
amount of FM modulation FM input
- - -
DETUNE Here you can set the amount of oscillator clone detuning.
SHIFT
CHORDS
The [SHIFT] button lets you use the Detune knob to sekect
various chords. A chord is built up from between 2 and 8
notes. You can control the number of involved notes with the
Density knob. To the right of the middle you will find Major and
to the left of the middle minor chords.
- - -
MOD-DEPTH
In the middle position, this controller is neutral. On the right
and left of the center position, the knob controls the
modulation depth of a modulation source connected to the
MOD input. To the left of the middle position, the modulation
source will modulate the waveform morphing, and values right
from the center will modulate the TLM modulation described
above. If you want to use the LFO for TLM or waveform
modulation, you will need to connect a cable from the output
of the LFO to the MOD input.
SHIFT
MOD-
WHEEL
While holding down the [SHIFT] key, the MOD-DEPTH knob
adjusts how much MIDI modulation wheel data a
ff ects the
strength of the vibrato.
Knobs and buttons of the Oscillator section.
Knob/Button Description
Knobs and buttons of the Oscillator section.
Button
In- and output jacks of the Oscillator setion.
Jack Input/Output Description
FM
Input This input is used to connect an FM modulation source. For
example, connect the output of another oscillator or LFO here.
The amount of FM modulation can be adjusted while holding
the [SHIFT] key with the density knob.
MOD
Input Depending on the position of the MOD DEPTH control, a
connected modulation voltage will a
ff ect either TLM
modulation or waveform morphing.
1V/OCT
Input
This input controls the pitch of the oscillator. An increase in
the control voltage by one volt causes a frequency doubling.
The input voltage at this jack can be quantized to common
tone scales. More about this can be found in chapter 3.2.1
"Scale Quantizer".
OUT
Output
This is the audio output of the swarm oscillator.
von 21 63