Rackable Systems OmniStor 4900F Series, Руководство пользователя

Страница: 60 / 196

Chapter 3 - Setup and Installation
Storage System Detailed Installation
46
Storage System Detailed Installation
This section describes preparing and installing the enclosure(s) into the rack cabinet
or the enclosure into its tower stand (refer to “Installing the Storage System into the Tower
Stand” on page 49.
After installing the hardware components, go to the “Operating Mode Configuration
and Cabling” section to cable the enclosure(s) for your selected topology.
Installing the Storage System Enclosure into the Rack Cabinet
1
Select an appropriate location within your rack cabinet.
Consider the location of the enclosures in relationship to each other and the host
server to ensure the cables will easily reach between them.
CAUTION:
The power supplies should be removed prior to installing the
enclosure into the rack cabinet. The enclosure chassis could be
damaged during installation due to the added unbalanced weight of
the power supplies.
2
Remove the storage system from its shipping carton and inspect for obvious
damage.
Remove and open the accessory kit, and remove the contents. Open the left and
right flaps, and remove the bezel and mounting rails.
Remove the drives from the foam tray, then remove the foam tray from the box.
Lift the enclosure from the box. Remove the foam from around the it and place
the enclosure on a flat surface to work from.
3
Remove the power supplies.
Grasp the power supply handle and slide the release latch to the right with your
thumb as you pull the power supply from the enclosure. Repeat for the other
power supply.
4
Locate the mounting rails and mounting hardware in the accessory kit (some
installations require cage nuts and others use standard nuts).