Rackable Systems OmniStor 4900F Series, Руководство пользователя

Страница: 173 / 196

Chapter 6 - Maintenance
Replacing the SES Controller Card
159
Replacing the SES Controller Card
WARNING:
THE SES CONTROLLER CARD IS NOT HOT-SWAPPABLE. You
must power down the storage enclosure to remove or install this card.
1
Power down the storage enclosure, refer to “Powering Off the Storage System”
on page 113.
2
Using a flat-blade screwdriver, loosen the two captive fastener screws that secure
the card.
3
Note the positions of the switch settings.
4
Using the captive fastener screws, gently pull the card from the enclosure.
5
Remove the new replacement card from the shipping container and inspect for
obvious damage. Save the packaging materials.
SES Controller Card Switches
6
Set the switch settings on the replacement card to match those of the faulty card.
7
Insert the replacement card by aligning it into the rail guides and push the card
until it fully seats.
Tighten the two captive fastener screws. Do not overtighten the screws.
8
Power-on the enclosure. Refer to “Powering On the Storage System” on
page 113.
9
Using the packaging materials from the replacement card, repackage the failed
card and return it per your RMA instructions.