6
Subject to technical change without notice
09.2003
7
Subject to technical change without notice
09.2003
09.2003
7a
7b
7c
7d
2.4 Reset
To restore the manufacturer’s settings
(standard values), a reset can be carried out
(fig. 7a-d)
.
The above parameters are then reapplied,
and the drill width must be input.
How to carry out a RESET:
•When switching on, immediately keep the
lower left soft key
<S1> (fig. 8)
pressed.
•Then confirm this with the
<Enter>
key
(fig. 7a-d)
.
•When the message ‘Enter drill width’ is
displayed, enter the width via the keypad,
and confirm with
<Enter>
.
•Wait for about 5 seconds before switching
off with the
<On/Off>
button.
•When switching on again, the
manufacturer’s settings have been loaded.
•The display language is English, and the
ground wheel radar factor is 0.00778 m/
impulse. If the machine has a ground wheel,
this factor must be re-entered
(4.1.2)
.
