![background image](http://html1.mh-extra.com/html/quest-engineering/dr4300e/dr4300e_owners-manual_772522011.webp)
DR4300 Owners Manual
Back panel features
11
Table 2. Back panel features
Item 1 is the system identification button on the front and back panels, that can be used to locate a particular system within a
rack. When one of these buttons is pressed, the LCD panel on the front and the system status indicator on the back flashes
until one of the buttons is pressed again. Press to toggle the system ID on and off. If the system stops responding during POST,
press and hold the system ID button for more than five seconds to enter BIOS progress mode. To reset iDRAC (if not disabled
in F2 iDRAC set up) press and hold the button for more than 15 seconds. Item 2 is System identification connector, that Enables
you to connect the optional system status indicator assembly through the optional cable management arm. Item 3 is iDRAC8
Enterprise port. It is a dedicated management port. The port is available for use only if the iDRAC8 Enterprise license is installed
on your system. Item 4 is PCIe expansion card slot, that Enables you to connect three low profile PCIe expansion cards. Item
5 is serial connector, that Enables you to connect a serial device to the system. Item 6 is video connector, that Enables you to
connect a VGA display to the system. Item 7 is USB ports (2), that Enables you to connect USB devices to the system. The
ports are USB 3.0-compliant. Item 8 is PCIe expansion card slot that Enables you to connect up to four full height three-fourth
length PCIe expansion cards. Item 9 are Ethernet connectors (4) that has four integrated 10/100/1000 Mbps NIC connectors or
four integrated connectors and two integrated 10/100/1000 Mbps NIC connectors, two integrated 100 Mbps/1 Gbps/10 Gbps
SFP+ connectors. Item 10 and 11 are power supply units (PSU1 and (PSU2) that supports 1100 W AC PSU. Item 12 is the SD
vFlash card slot that Enables you to insert a vFlash media card. Item 13 is the rear hard drive slots that allow you to install up to
two hot-swappable 2.5-inch hard drives
Item
Indicator, button, or
connector
Icon
Description
1
System identification
button
The identification buttons on the front and back
panels can be used to locate a particular system
within a rack.
Press to toggle the system identification (ID) on or
off.
If the system stops responding during POST, press
and hold the system ID button for more than five
seconds to enter BIOS progress mode.
To reset iDRAC (if not disabled in F2 iDRAC set up)
press and hold the button for more than 15 seconds.
2
System identification
connector
Connects the optional system status indicator
assembly through the optional cable management
arm.
3
iDRAC8 Enterprise port
Dedicated management port.
4
Half-height PCIe
expansion card slot (3)
Enables you to connect up to 3 half-height PCI
Express expansion cards.
5
Serial connector
Enables you to connect a serial device to the
system.
6
Video connector
Enables you to connect a VGA display to the
system.
7
USB port (2)
Enables you to connect USB devices to the system.
The ports are USB 3.0-compliant.
8
Full-height PCIe
expansion card slot (3)
Enables you to connect up to 3 full-height PCI
Express expansion cards.
9
Ethernet connector (4)
Four integrated 10/100/1000 Mbps Network
Interface Card (NIC) connectors
Содержание DR4300e
Страница 1: ...DR4300e System Owner s Manual ...
Страница 181: ...DR4300 Owners Manual 181 Index ...