![background image](http://html1.mh-extra.com/html/quest-engineering/dr4300e/dr4300e_owners-manual_772522105.webp)
DR4300 Owners Manual
Removing an expansion card from the expansion card riser 1
105
3. Disconnect any cables connected to the expansion card.
4. Remove the expansion card riser.
NOTE:
The expansion card riser 1 can be used only when both the processors are installed.
1. Press tab A and rotate the latch clockwise.
2. Press tab B and rotate the latch downward.
3. Remove the expansion card from the expansion card riser 1.
4. If you are removing the card permanently, install a metal filler bracket over the empty expansion slot
opening, and then close the expansion card latch.
NOTE:
You must install a filler bracket over an empty expansion card slot to maintain Federal
Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt
out of the system and aid in proper cooling and airflow inside the system.
5. Close the latches of tab A and tab B.
Figure 34. Removing an expansion card from expansion card riser 1
a. tab A
b. expansion card riser 1 cage
c. expansion card connector
d. tab B
e. latch
f.
expansion card
1. Install the expansion card.
2. Install the expansion card riser.
3. Follow the procedure listed in the After working inside your system section.
Related tasks
See also:
Before working inside your system
See also:
Removing expansion card risers
See also:
Installing an expansion card into the expansion card riser 1
See also:
Installing expansion card risers
See also:
After working inside your system
Related references
Содержание DR4300e
Страница 1: ...DR4300e System Owner s Manual ...
Страница 181: ...DR4300 Owners Manual 181 Index ...