Qlogic SANsurfer iSCSI HBA CLI, Руководство пользователя

Страница: 55 / 184

4 – Interactive Mode Commands
Port Level Info & Operations Menu
SN0054621-00 E 4-21
A
Link Local Address : fe80::2c0:ddff:fe08:5a13
IPv6 Local Address State : Valid (0x5)
IPv6 Address 0 : Source Address Not Valid
IPv6 Address 1 : Source Address Not Valid
IPv6 Default Router : Router Address Not Valid
IPv6 Port Number : 3260
IPv6 Router Adv Link MTU : 0 bytes
iSNS : Disabled.
Configure IP Settings
(CLI Option -ipdhcp)
Select the Configure IP Settings menu to enable or disable the following
features:
„ Enable IPv4
„ DHCP to obtain IPv4 Network Information
„ Enable IPv6
„ Obtain Link Local Auto
„ Obtain Routable Address Auto
„ Obtain Router Address Auto
„ IPv6 Default Router IP Address
You are prompted to turn on or off each feature; the current state is shown at the
end of the prompt. For example, the following prompt indicates that the router
address is not obtained automatically:
Obtain Router Addr Auto [off] :
To change this setting, type
on
, and then press
ENTER
(be sure to turn off the
CAPS LOCK
key; entries are case sensitive). If you do not want to change this
setting, press
ENTER
.
iSNS Settings
(CLI Option -isns)
By default, iSNS is disabled. Use iSNS when extended discovery management
capabilities (for example, notifications, access management, and configuration)
are required, such as in larger storage networks.
To enable iSNS, type
on
at the
Use iSNS: [off]
prompt, and then press
ENTER
. You are prompted to enter an iSNS IP address.