Qlogic SANsurfer iSCSI HBA CLI, Руководство пользователя

Страница: 49 / 184

4 – Interactive Mode Commands
HBA Level Info & Operations Menu (CLI Option -i)
SN0054621-00 E 4-15
A
HBA Diagnostic Menu
(No CLI Option)
The HBA Diagnostic Menu provides the following options:
1. Retrieve FW Crash Record
(see page 4-15 )
2. Retrieve FW Flash & NVRAM Record
(see page 4-15 )
3. Retrieve FW Coredump Record
(see page 4-16 )
4. Display HBA Level Statistics
(see page 4-16 )
5. Select HBA Port
(see page 4-49 )
6. Refresh
(see page 4-49 )
7. Exit
(see page 4-50 )
Before making a selection from the HBA Diagnostic Menu , specify the HBA port
you want to view or change by typing the number for Select HBA Port , and then
pressing
ENTER
. A list of all iSCSI HBA ports is shown. Type the number for the
HBA port whose settings you want to change, and then press
ENTER
.
Make changes in the submenus, as described in the following sections.
After making changes, refresh the HBA to show these changes by typing the
number for (
Refresh ), and then pressing
ENTER
. If you do not select this option,
your changes will not be visible in SANsurfer iSCSI HBA CLI.
Retrieve FW Crash Record
(CLI Option -gcr)
Select the Retrieve FW Crash Record option to get crash record information for
the HBA. At the prompt, type a name and location for the crash file, and then
press
ENTER
. Be sure to use full path names. For example:
Crash File Name: c:\QLogic_Corporation\iscli\crash_record
Retrieve FW Flash & NVRAM Record
(CLI Option -dumpnvram)
When you select the Retrieve FW Flash & NVRAM Record option, SANsurfer
iSCSI HBA CLI queries you for the name of a file in which to dump the Flash and
NVRAM contents. Be sure to use full path names. For example:
What is the filename you would like to save this Host NVRAM to:
c:\QLogic_Corporation\iscli\NVRAM_dump
NOTE:
„ Issuing this command resets both ports (0 and 1) on the HBA.
„ You must disable bootcode mode (see “-bootcodemode (Set BIOS/UEFI
[or FCode] Mode)” on page 5-4 ) to reset the HBA.