Qlogic SANsurfer iSCSI HBA CLI, Руководство пользователя

Страница: 107 / 184

5 – Non-Interactive Mode Commands
Non-interactive Commands
SN0054621-00 E 5-23
A
To set only the local link address, enter the following:
-netconf6 0 -IPLL fe80::1
To set everything automatically, enter the following:
-netconf6 0 -IPLLA -IPR01A -IPRRA
To disable the IPv4 network, enter the following:
-netconf6 0 -DISN4
To disables the IPv4 and IPv6 networks:
-netconf6 0 -DISN4 DISN6
For information on the interactive version of this command, see “Configure IPv6
Settings (CLI Options -netconf, -netconf6, -isns, -isns6, -ip, and -nc)” on
page 4-27
.
-nh
(Configure iSCSI Settings)
To set the HBA level parameters for multiport HBAs, enter the
-nh
command as
follows:
-nh <hba_port_inst> < Config name | Config alias > < Value >
[<< Config name | Config alias >> < Value >
…
]
The valid parameters and their values are shown in Table 5-3 . For a complete list
of HBA parameters, see Appendix C Target Parameters .
For information on the interactive version of this command, see “Configure iSCSI
Settings (CLI Options -n and -nh)” on page 4-24 .
-pa
(Add a Target)
To add persistent targets, enter the
-pa
command as follows:
-pa < hba_port_inst > < IP Address > [-PORT port number ] [-INAME iSCSI
Name ]
If you do not specify a port number
[-PORT
port number
]
, SANsurfer iSCSI
HBA CLI uses the default number 3260. If you do not specify an iSCSI name,
[-INAME iSCSI Name ]
SANsurfer iSCSI HBA CLI uses the default value, an
empty string.
For information on the interactive version of this command, see “Add a Target (CLI
Option -pa)” on page 4-40 .