Qlogic SANsurfer iSCSI HBA CLI, Руководство пользователя

Страница: 103 / 184

5 – Non-Interactive Mode Commands
Non-interactive Commands
SN0054621-00 E 5-19
A
-linkchap
(Assign a CHAP Entry to a Target)
To link a CHAP entry to a target, enter the
-linkchap
command as follows:
-linkchap < hba_port_inst > < CHAP No. > < Target ID >
This command does not reset the HBA.
For information on the interactive version of this command “Assign a CHAP Entry
to a Target (CLI Option -linkchap)” on page 4-42 .
-lp
The IPv6 local prefix list is created based on prefix information from router
advertisements. Destination IP addresses containing these prefixes can be
reached directly, without going through an intermediate router.
To display the local prefix list, enter the
-lp
command as follows:
-lp < hba_port_inst >
There is no corresponding interactive mode option for this command.
-model
To view the HBA “model(s)” (board type[s]) in the system, enter the
-model
command as follows:
-model
There is no corresponding interactive mode option for this command.
-n
(Configure iSCSI Settings)
To set to HBA iSCSI parameters for single port HBAs, enter the
-n
command as
follows:
-n < HBA No. > < Config Name | Config Alias > < Value >
[< Config Name | Config Alias > < Value >
…
]
After you issue this command, the HBA is reset.
You can repeat the
< Config Name | Config Alias > < Value >
parameter set
for as many parameters as you want to configure. Table 5-3 lists these parameters
and their ranges of values.
Table 5-3. HBA Parameters
Configuration Name Configuration Alias Value
Add Firmware Options
AFW_AutoConnect AFWAC on or off