Qlogic SANsurfer iSCSI HBA CLI, Руководство пользователя

Страница: 111 / 184

5 – Non-Interactive Mode Commands
Non-interactive Commands
SN0054621-00 E 5-27
A
-rdh
(Port Restore Factory Defaults)
Type the following command to restore the specified HBA port’s settings to their
factory defaults:
-rdh <hba_port_inst> [A] [F N I T C V]
Where:
If you want to restore all areas of the HBA port, either use the
A
parameter, or use
no parameter. Otherwise, specify which areas to restore. For example, the
following command restores the firmware and NVRAM to the factory defaults:
-rdh <hba_port_inst> F N
For information on the interactive version of this command, see “Port Restore
Factory Defaults (CLI Option -rdh)” on page 4-28 .
NOTE:
The
-rdh
command is not supported in the QLA4010 HBA.
hba_port_inst
= HBA port whose factory settings you want to restore.
A
= Restores the factory settings for the entire HBA (firmware parame-
ters, network parameters, iSCSI name, targets, CHAP table,
NVARAM, and IPSec).
Issuing this command resets the HBA. If you use this option, no
others are necessary.
F
= Restores firmware parameters to the factory default values.
Issuing this command resets the HBA.
N
= Restores network parameters to the factory default values.
Issuing this command resets the HBA.
I
= Restores the iSCSI name to the factory default value.
Issuing this command resets the HBA.
T
= Restores the targets to the factory default values.
C
= Restores the CHAP table to the factory default values.
V
= Restores the NVRAM to the factory default values.