3 – Event Messages
Alarm Events
59060-04 A
3-29
A
(A1005.006E) (A reset is required to activate this version of firmware)
Meaning:
The installed firmware cannot be activated without disrupting I/O
traffic.
Action:
Perform a hard reset.
(A1005.006F) (Hotreset Vversion -> Vversion is not supported)
Meaning:
The installed firmware cannot be activated without disrupting I/O
traffic.
Action:
Perform a hard reset.
(A1005.0070) (Hotreset to older firmware version not supported. A reset is required to
activate this version of firmware)
Meaning:
The installed firmware cannot be activated without disrupting I/O
traffic.
Action:
Perform a hard reset.
(A1005.0071) (Unable to obtain dynamic IP address, falling back to static IP address of
address on interface interface)
Meaning:
The switch was unable to obtain its IP address from the Dynamic
Host Configuration Protocol (DHCP) server. The static IP address
will be used.
Action:
Investigate the DHCP server.
(A1005.0072) (Unable to turn off lasers, please power off the switch)
Meaning:
Conditions exist that could damage the switch and the switch was
unable to turn off the Fiber Channel port lasers.
Action:
Power down the switch and contact your authorized maintenance
provider.
(A1005.0073)(Blade fault fault reported)
Meaning:
The named blade fault has occurred.
Action:
Contact your authorized maintenance provider.
(A1005.0074) (Blade seating is questionable)
Meaning:
A SANbox 9000 blade is improperly installed.
Action:
Examine the switch and reinstall blades as needed.
(A1005.0075) (Blade seating problem was resolved)
Meaning:
The SANbox 9000 blade seating problem as resolved.
Action:
None.
