3 – Event Messages
Alarm Events
59060-04 A
3-27
A
(A1005.005F) (Canceling Nicknames edit mode as a result of a CPU switchover)
Meaning:
A CPU blade switchover occurred while a nicknames edit session
was in progress. The edit session was canceled.
Action:
Reopen the nicknames edit session.
(A1005.0060) (A control link between blade_ID and blade_ID (via blade_ID) has failed, blade
control is not fully redundant, contact technical support.).
Meaning:
A portion of the control plane network on the switch has failed. The
switch should continue to function normally, but any further failures
may cause the switch to malfunction.
Action:
Contact your authorized maintenance provider.
(A1005.0061) (A control link between blade_ID and blade_ID (via blade_ID) is now
functioning normally.
Meaning:
The control link has recovered and is functioning normally.
Action:
None.
(A1005.0063) (CPU never entered HotStandby state)
Meaning:
Secondary CPU never entered HotStandby state, and therefore the
switch is not fault tolerant.
Action:
Contact your authorized maintenance provider.
(A1005.0064) (Switch is not fault-tolerant. Fault Tolerant license is installed, but only 1
CPU blade installed)
Meaning:
The Fault Tolerant license key was installed on a SANbox 9000
switch with only one CPU blade.
Action:
Install the second CPU blade.
(A1005.0065) (Fault Tolerant license is installed, but secondary CPU's latch is open so
unable to become Fault Tolerant)
Meaning:
The SANbox 9000 switch is not fault tolerant because the
secondary CPU blade is not fully installed.
Action:
Close the secondary CPU blade latch.
(A1005.0066) (Switch is not fault-tolerant. Fault Tolerant license is installed, but secondary
CPU is faulted)
Meaning:
The SANbox 9000 switch is not fault tolerant because of a fault on
the secondary CPU blade.
Action:
Replace the secondary CPU blade.
