Prophete REX ATB, Руководство по эксплуатации

Страница: 73 / 308

Eng
lish
EN 11
HANDLEBAR
SETTING THE INCLINATION
1. Loosen the clamp spindle screw
2
(fig. C + D) with a 5 or 6 mm hexagon socket wrench, de -
pending on the version installed.
2. Adjust the inclination angle of the handlebar.
3. Turn the handlebar attachments (e.g. brake lever) back to the starting position.
4. Tighten the clamp spindle screw
2
(fig. C + D) again well according to the torque specification
(s. chapter torque specifications).
STEM WITH ANGLE ADJUSTMENT
SETTING THE POSITION AND HEIGHT
1. Loosen the clamp screw
1
(fig. F) with a 6 mm hexagon
socket wrench.
2. You can now set the handlebar position or the stem height.
Always observe the mark of the minimum insertion depth.
3. Tighten the clamp screw
1
(fig. F) again according to the
torque specification (s. chapter torque specifications).
SET STEM ANGLE
1. Loosen the lateral clamp screw
3
(fig. F) with a 6 mm hexa -
gon socket wrench.
2. Now adjust the desired angle at the stem.
3. Then tighten the clamp screw
3
(fig. F) again according to
the torque specification (s. chapter torque specifications).
SET HANDLEBAR INCLINATION
1. First loosen the clamp block screw
1
(fig. G) of the handle -
bar attachment with a 4 or 5 mm hexagonal socket wrench.
2. Adjust the inclination angle of the handlebar.
3. Tighten the clamp block screw
1
(fig. G) again well (s. chapter
Torque specifications).
4. Turn the handlebar attachments (e.g. brake lever) back to the
starting position if necessary.
DANGER
• The stem must not be pulled out beyond the mark
2
(fig. F)! The mark of the minimum in -
sertion depth
2
(fig. F) must not be visible. Danger of damage and accidents! - No warran -
ty if this is not observed!
F
2
1
3
1
G
1
1 1